I just have a quick question about the DIY accessories for AIBI. On the DIY accessories page there is official downloads, one of them being ‘Wukong’, I only have a normal 3D printer, and for the staff (Jingubang), there is 2 pieces, one being the staff itself, and one being an attachment piece for the staff to slide in, but I was wondering how the staff’s attachment piece can connect to AIBI, since my 3D printer cannot print magnetic pieces. Using similar reasoning, I assume AIBI just sits on the cloud and the headband just rests on his head, but they cannot magnetically attach, is that right? I’ve already printed the cloud, and have observed that it has 2 circle indents similar to the ginger cat or bunny rubber pieces, but, as stated previously, unlike the animal pieces, my cloud isn’t magnetic.
Under and inside AIBI’s body, back, and head, there are “Micro n52 Magnets”. That’s why, when placed on a metal surface, AIBI can stand without using the bunny or cat rubber feet. The same applies when the bunny and cat headwear is attached—it can also stick to the head because there is also a “Micro n52 Magnets” in the head area.
The bunny and cat accessories have two hidden magnets in their feet and head, which help them attach to AIBI’s body and head—most likely using opposite magnetic poles (positive and negative) for attraction.
